High Heat Density Cooling Solutions
High heat density cooling solutions from Vertiv/Liebert offer you modular options to optimize your data center infrastructure. These solutions are available in a broad range of configurations, including open or closed architecture. They’re also available with pumped refrigerant or water-based technology. Browse our selection of high heat density cooling modules below. Need help to select the right equipment? Try our Thermal Management Selection Tool to get a customized recommendation.
The Liebert XDA optimized data center racks by increasing air flow through densely populated enclosures, past congested cabling; removing hot spots within the enclosure.
Overhead cooling module mounts directly above the cold aisle, requiring no floor space; available with Smart Module integrated control board for increased module control and monitoring.
Liebert XDV vertical top cooler is installed on or above a rack enclosure. It draws hot air from inside the enclosure or from the Hot Aisle, then cools the air and discharges it down into the Cold Aisle. Connects via flexible piping and uses pumped refrigerant technology. The rack or ceiling-mounted Liebert XDV is available in nominal capacities of 8.8kW (2.5 Tons) and 10kW (2.8 Tons) for 60Hz applications; and 8kW (2.3 Tons) for 50Hz applications. This pumped refrigerant-based system is backed by the Liebert XDC Chiller, or the Liebert XDP Pumping Unit.
Row-based cooling module is placed directly in line with the rack enclosures and requires very little floor space.
Designed for the specific cooling needs of the Egenera BladeFrame EX. It mounts directly to the back of the rack requiring no additional floor space.
A system matched pumping unit. Designed to support Liebert XDO, Liebert XDH and Liebert XD CoolFrame spot / zone cooling units.
Refrigerant chiller is a specially designed indoor unit that connects directly to Liebert XDO, Liebert XDH and Liebert XD CoolFrame units providing chilled, pumped refrigerant circulation and control.
Liebert DCD rack cooler replaces the rear door of an enclosure, providing cooling without increasing the rack footprint. The module uses the server fans within the protected rack to provide airflow, providing the most energy efficient design.
Houses the isolating heat exchanger between the Liebert DCD or Liebert XDK-W and the building chilled water. It circulates the chilled water to the cooling modules at a temperature always above the actual dew point to prevent condensation.